Reducer after sales problems

Reducer after sales problems

2021-08-27 01:40:04

The newly put into operation of the reducer, in the operation of 200 ~ 300 hours, should be times of oil change, in the future use should regularly check the quality of oil, for mixed impurities or metamorphic oil must be replaced in time. In general, the SEW reducer for long-term continuous work, according to run 5000 hours, or once a year to replace the new oil, stop using the speed reducer for a long time, should also be replaced before running again new oil reducer should join the same as the original brand of oil, may not be used with different type of oil phase, the same brand but different viscosity oil allow mix. When changing oil, wait for the reducer to cool down until there is no burning danger, but still should keep warm. Because the viscosity of oil increases after complete cooling, it is difficult to discharge oil.

Note: to cut off the power supply of the transmission device to prevent inadvertant electrification! During the work, when the oil temperature rises more than 80℃ or the oil pool temperature exceeds 100℃ and produces abnormal noise and other phenomena, the use should be stopped, the cause should be checked, the fault must be eliminated, and the lubricating oil must be replaced before the operation can continue. Users should use and maintain reasonable rules and regulations, carefully record the operation of the reducer and the problems found in the inspection, and the above provisions should be strictly implemented. Five, the selection of lubricating oil SEW reducer before put into operation must add appropriate viscosity of lubricating oil, to reduce the friction between the gears, in case of high load and impact load, reducer can give full play to its function. After 200 hours of use, the lubricating oil must be discharged and cleaned, and then new lubricating oil must be added to the center of the oil standard. Too high or too low oil level may lead to abnormal operating temperature.